17
T.2T ZIP
16
8 Additional remote control
P
A
A
P
A
“clic”
“clic”
“clic-clic”
T.2T ZIP
1)
Hold down the PROGRAM button on the MAIN REMOTE
CONTROL (already programmed) until the motor confirms
the operation with a CLICK.
2)
Hold down the PROGRAM button on the ADDITIONAL OR SPARE
REMOTE CONTROL (to be programmed) until the motor confirms
the operation with a CLICK.
3)
Hold down the PROGRAM button on the ADDITIONAL OR SPARE
REMOTE CONTROL (to be programmed) until the motor confirms the
operation with a DOUBLE CLICK.
4)
PROGRAMMING OVER, the roller blind can work with 2 remote
controls.
Other than the main one, up to 15 remote controls can be
added.
MAIN remote control
(already programmed)
ADDITIONAL remote control
(to be programmed)
i
IMPORTANT
: in case of remote control loss or breakage
1)
Cut the power for about 10 seconds then turn back on
2)
Hold down the
button on the
until the motor confirms the operation with a
3)
Programming over, the
has memorized the previous one’s limit switch (the limit switch does not need to be
reset)
PROGRAM
NEW REMOTE CONTROL
DOUBLE CLICK.
NEW REMOTE CONTROL
FANANI / ASSEMBLY INSTRUCTIONS
FANANI / ASSEMBLY INSTRUCTIONS
Troubleshooting 9
Bottom rail descend out of square.
Side guides are not perfectly aligned
Put the guides in square position.
Roller blind operated in presence of
strong wind
Close the roller blind.
The guides doesn’t fit into the window
opening
The fabric does not move
Wrong measures survey
Obstacles inside the guide
Verify the measures and trim the guides.
Disassemble the internal guide and check
the guide cleaning
MOTOR OPERATION
The motor perceives the command only if
the remote control is close
Remote control battery needs changing
Replace the battery
IRREGULARITY
POSSIBLE CAUSE
SOLUTION
The awning does not move
Lack of power
Make sure there is mains power.
Defective electrical connection
Check the wiring (up to an electrician)
The termal circuit cutoff entervened
because the roller blind was operated
repeatedly without a pause
Wait from 15 to 30 minutes until the
motor has cooled down
Summary of Contents for myShell T.2T ZIP
Page 1: ...Rev 1 03 17 T 2TZIP ASSEMBLY INSTRUCTIONS...
Page 2: ......
