(10)Except the maintenance of the equipment, it is not allowed to take off the
guards of the belt pulley.
(11) When the safety guards or operating gates have to be opened or the safety
devices have to be disassembled in order to inspect, adjust, repair and
maintain the equipment or replace the parts, required safety measures must be
in place prior to such operations.
(12)When the machine is running, it is strictly forbidden to put fingers near the
running components.Such work as inspection, maintenance and cleaning etc
cannot be done until the principal machine have been completely stopped.
(13) In case maintenance and inspection work should be done with a welder or
other tools that can generate sparks, strict safety precautions must be taken
against dust explosion and combustion (see "Explosion protection").
(14)If the parts are damaged, please repair or replace them immediately.
(15)Ensure the safety of the electric system. Before the electric circuit is cut off,
it is strictly prohibited to open the junction box to avoid electric shock.
(16)The electric control system of the pellet mill must comply with the following
instructions. Otherwise, the technical safety responsibility of the supplier will be
denied.
①
The electric control system of the pellet mill must be supplied by Muyang.
②
The equipment must be checked up by an expert from Muyang before
commissioning.
③
The electric control is a component part of the safety regulations for accident
prevention.
④
Prior to commissioning the control system must be tested by an expert from
Muyangaccording to the testing list and a permit will be signed off by the expert.
⑤
If the control system for Muyang equipment does not go through the
conditions above, Muyang will deny any responsibility. If Muyang is required to
take the responsibility, we will reserve the right to investigate and affix the
liability of the party who is responsible.
