27
8.2.3.6 End of installation test
Please refer to section 8.2.2.4 End of installation test.
8.2.4 How to install the front casing
The installation of the front casing for wall and pole is the same, and it is done by fitting and then
sliding it down.
Close
Open
Finally, the lock placed at the bottom of the casing makes it possible to secure the unit.
8.2.5 Troubleshooting & Maintenance
8.2.5.1 Troubleshooting
Refer to the table below to identify and resolve the problem.
Problem
Solution
No voltage + 5V DC detected in the central
connector
1. Check that the DC power input is at the
terminal block
2. Check that the cable ends are inserted
into the terminal block.
3. Check the condition of the fuse under
the terminal block casing
The recommendation on the number of
spacers on the brackets does not match the
actual topology of the bar
Some tolerances have been identified, in
some rare cases. The installer can change the
number of spacers as long as it:
