30
cm以上
以上
Do not expose the chair to sudden changes in
temperature. If the room where the chair is to be used is
cold, turn the heat up slowly. If the chair is to be moved
from a cold place into a heated room, wait one hour
before using the chair.
→
Condensation can occur in the moving parts of the
chair, which may compromise performance.
How to adjust the footrest
How to adjust angle of the footrest
How to sit in the chair
Armrest (right) side
Screw
Footrest
adjustment
lever
Remote control stand
20 inches
12 inches
as this
*
*
Before each use, check for holes or tears in
the chair fabric (lift back pad). Do not use
the chair if there are any holes or tears in
the chair fabric or upholstery.
Disconnect the plug and consult
the vendor immediately.
→
Using the chair with holes or
tears in the chair fabric could
result in injury or electric shock.
Make sure that your fingers or
any other objects are not
caught between the footrest
and footrest adjustment lever
to avoid injury and/or accident.
The auto timer function will
automatically stop the chair. However,
you should be familiar with how to
manually turn off the power after use to
prevent an accidental start of the chair.
Place the chair at least 3 feet away from a TV, radio, or other AV equipment. It may cause noise in the equipment.
Attach the stand to the right armrest of main body using the
screw included, as shown in the figure.
Press and hold the reclining button labeled "DOWN" until
the desired angle is obtained.
Press and hold the reclining button labeled "UP" until the
desired angle is obtained.
adjust the footrest so that your calves are resting
comfortably on it.
Turn off the main power switch and be sure to disconnect
the plug from the socket.
How to attach the stand for the remote control
Make sure the footrest is down. When the chair power is off, the rollers are normally drawn back into the left and right sides
of the upper part of the backrest (storage position). For safety reasons, first check the position of the rollers. If they are in
any position other than the storage position, turn the main POWER switch on before sitting down to allow the rollers to
return to the storage position. Then sit down slowly with your back centered in the backrest.
UP/DOWN
2.The main power switch is on the right side of the
backrest. Turn the power on and the display on the
remote control will light up.
main
Summary of Contents for HCP-i2A
Page 7: ......
