45
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
For safety reasons curtains must not be fitted immediately
behind the cooker.
We recommend a gap of 1110mm between units to allow
for moving the cooker. Do not box the cooker in; it must still
be possible to move the cooker in and out for cleaning and
servicing.
A clearance of 130mm is required if the cooker is near a
corner of the kitchen to allow the oven doors to open. The
actual opening of the doors is slightly less but this allows for
some protection of your hand as you open the door.
Unpacking the Cooker
Do not take any packaging off the cooker until it is directly
in front of the place it is to be installed (unless it will not fit
through a door in its outer packaging).
Cut the banding straps and lift the cardboard box off the
cooker, leaving the cooker standing on the base packaging.
See the loose unpacking sheet.
Moving the Cooker
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker. Ensure
that the floor covering is firmly fixed, or removed to prevent
it being disturbed when moving the cooker around. You will
need the levelling tool.
From the back tilt the cooker forward and remove the rear
half of the polystyrene base pack.
Repeat from the front and remove the front half of the poly
base. Pull the drawer out to its furthest point.
Lift up the ends of the plastic clips (one each side) to release
the catches holding the drawer to the side runners and at
the same time pull the drawer forward and away from the
side runners. For safety’s sake push the drawer runners back
out of the way. Put the drawer somewhere safe - do not refit
it until the installation is complete.
Lower the Rollers.
Fit the Allen key tool to the centre roller lowering
mechanism (C in the fig. below).
A - left rear roller, B - right rear roller, C - centre roller
LOWER THE FRONT ROLLER by doing 14 complete (360°)
turns clockwise.
Now LOWER THE TWO REAR ROLLERS.
First fit the levelling tool on the hexagonal adjusting nut as
shown below.
Make 10 complete (360°) turns clockwise. (This means
turning and removing the levelling tool 20 times).
