STEP 16
A.
If the cylinder and lever are installed, refer to Step 13 for
lever removal instructions.
B.
Using a thin flat screw driver, turn the action bar slot clockwise
(cw) until it stops at about 2:00.
C.
Then turn the action bar counterclockwise (ccw) to the 9:00
position.
NOTE: There is no physical stop at this location.
D.
With the key out, install the standard cylinder into the spindle.
E.
Refer to Step 13 for lever re-installation.
F.
Operate the key to test for proper operation.
TIMING INSTRUCTIONS FOR STANDARD CYLINDER LOCKS
FOR THE FOLLOWING FUNCTIONS:
T351, T381, T561, T571
STEP 17
TIMING INSTRUCTIONS FOR IC CORE LOCKS
FOR THE FOLLOWING FUNCTIONS:
T351, T381, T561, T571
STEP 18
TAILPIECE INSTALLATION INSTRUCTIONS FOR T381 FUNCTION
STEP 19
A.
Determine the hand of the door.
B.
On the side closest to the door stop, remove the shaded area as shown.
Use a standard rotary file
³⁄₈
" diameter maximum.
C.
Try the latch for fit and function.
D.
Secure the latch with two (2) #8-32 machine screws provided.
INSTALLATION INSTRUCTIONS FOR OPTIONAL
³⁄₄
"
PROJECTION LATCH
A.
If the core is installed, refer to Step 11 for IC core removal instructions.
B.
Using a thin flat screw driver, turn the action bar slot clockwise
(cw) until it stops at about 11:00.
C.
Then turn the action bar counterclockwise (ccw) to the 7:00
position.
NOTE: There is no physical stop is at this location.
D.
Using the control key, insert IC core into the lever and spindle.
E.
Remove the control key.
F.
Operate the key to test for proper operation.
SEE STEP 14 FOR STANDARD CYLINDER
TAILPIECE INSTALLATION
SEE STEP 12 FOR IC CORE
TAILPIECE INSTALLATION
RH Shown
Action
bar
slot
Door
edge
RH Shown
Action
bar
slot
Door
edge
Door stop
on this side
1"
MIN
REF
1
¹⁄₁₆
" MIN REF
LONG TAILPIECE
SHORT TAILPIECE
OUTER STANDARD CYLINDER ASSEMBLY
INNER STANDARD CYLINDER ASSEMBLY
CLUTCH
ON
OUTSIDE
LONG TAILPIECE
SHORT TAILPIECE
OUTER IC CORE ASSEMBLY
INNER IC CORE ASSEMBLY
800-266-4456
©2010 Schlage Lock Company
Printed in Country
030794-000-70 Rev. 05/10-d