STEP 12
IC CORE AND TAILPIECE
Be certain to use the correct tailpiece with the core.
Six pin cores should only use the "6P" tailpiece.
Seven pin cores should only use the "7P" tailpiece.
6 Pin Core
7 Pin Core
FALCON
FALCON
STEP 13
TO REMOVE ALL CYLINDER LEVERS
(Except Interchangeable Core)
TO RE-INSTALL THE LEVER
A.
Insert the key and rotate clockwise
approximately 60 degrees.
B.
Depress lever retainer with tool provided.
C.
Slide lever off spindle.
D.
Insert cylinder into spindle.
E.
Slide lever onto spindle.
F.
Insert key into cylinder and rotate clockwise approximately
60 degrees and push lever over retainer.
G.
Pull on lever to be sure the retainer is engaged with the lever.
STEP 14
TAILPIECE INSTALLATION
For proper function of the lock, the tailpiece must be
installed correctly.
All T-Series tailpieces should be installed
VERTICALLY
in the cylinder.
STEP 15
SINGLE DUMMY TRIM, T12
A.
Using the template described in Step 1,
locate and mark the center for
two (2) mounting holes.
B.
For Wood Door
- Drill two (2) pilot holes
⁵⁄₃₂
" (4 mm) x
⁷⁄₈
" (22 mm) deep for #12 wood screws.
For Metal Door
- Drill and tap two (2) holes
for #12-24 machine screws.
C. Position the spindle assembly over the
mounting
holes and secure to the door
with
the screws provided.
D.
See Step 6 for lever installation.
C
A
B
Inner Trim Assembly
Groove
Inside of Door
Screws for Metal Doors
#12-24 x
³⁄₄
"
Screws for Wood Doors
#12 x 1
¹⁄₂
"
Cylinder
Spring
Pin
Tailpiece
Cap