STEP 5
INSTALL INNER TRIM ASSEMBLY
Slide the inner trim assembly over the chassis spindle. Thru-posts will
engage the inner trim asembly on 1
³⁄₄
" (45 mm) thick doors.
Secure to the door with two #10-32 x 1" machine screws provided.
STEP 6
INSTALL INNER LEVER
A. Position the rose over the inner trim assembly making
sure the rose detent engages the groove in the
spindle assembly.
B.
Install the lever handle and tighten the set screw with
the hex key provided.
STOP! Test operation to be sure the latch bolt moves freely.
DO NOT FORCE.
If the lockset does not operate properly, remove the
lockset from the door and check the door preparation and door thickness
adjustment. Go back to Step 3 to re-install the chassis.
STEP 7
LOCATE AND INSTALL THE STRIKE
A. For
wood jambs, center the strike latch opening over 1" (25 mm)
hole in jamb. Trace the outline around the strike on the door jamb.
B.
Mortise the door jamb to accommodate the strike box
and the strike.
C.
Insert the strike box if required and fasten the strike to the
jamb with #12 or #8 combination screws provided.
Caution: Deadlocking plunger of the latch bolt must not enter the
opening in the strike plate.
Note: When the strike box is not used, the recess in the jamb must
be a minimum of
⁹⁄₁₆
" (14 mm) deep to allow the latch bolt to extend
to its full projection.
STEP 8
A.
Remove the outside trim retaining screw (A).
B.
Slide the outside trim (B) from the chassis assembly.
C.
See Step 9 for chassis adjustment procedure,
or Step 10 for spacer installation.
D.
Slide the outside trim (B) onto the chassis.
E.
Replace the outside trim retaining screw (A).
INSTRUCTIONS FOR REMOVING OUTSIDE TRIM
Thru Post
Inner Trim Asssembly
Mounting Screws
#10-32 x 1"
Thru Post
Chassis Spindle
Groove
Rose Detent
¹⁄₄
-20 x
¹⁄₄
"
Set Screw
Inner Trim Assembly
Rose
Inner Lever
Jamb
ANSI Dust Box
ANSI Strike
#12 Combination Screw
Mortise for
dust box
and strike
Jamb
Dust Box
T-Strike
#8 Combination
Screw
Mortise for
dust box
and strike
A
B
