- 5 -- 5
Emergency Override
Follow the steps as below to override the system:
- With the system armed or alarming
- Turn the ignition on (or off then on)
- After 2 sec. the LED will flash 10 times slowly
- Press the valet switch once after the LED flashes a number of times equal to the PIN
- The system will be overridden and enter disarm mode
* Repeat the steps from turning the ignition on if the previous operation is failed
* Wait for 3 minutes and operate the override procedure again after 3 times of incorrect operation
* The PIN will be required for overriding the system the following situations:
1. If the remote control doesn’t work
2. To deactivate the anti-hijacking
3. To deactivate the Entry Delay(option features #12)
4. To deactivate the AED(option features #9)
Valet Mode
Valet mode is a convenient feature to use when you hand the remotes to third person for valet parking or vehicle
service and the operation is as follows:
- With the system disarmed
- Turn the ignition on
- Within 10 seconds press the valet switch for 2 seconds
- The LED will turn on
- The system enters the valet mode
* To exit valet mode repeat the steps above again, the LED will be turned off to confirm leaving the valet mode.
* Under valet mode and with the ignition off, pressing buttons #1 and #2 will be still lock and unlock the doors.
* The anti-hijacking will not be activated with the system valet mode.
Car Finder
The Car Finder function will work with the system armed or disarmed but the ignition must be off. The operation is as
follows:
- Press button #4 once:
The hazard lights will flash 6 times
- Press and hold button #4 and 2 seconds later:
The hazard lights will flash and the siren will chirp till button #4 is released.
Shock Sensor Temporary Bypass
Press Button #1 again within 2 seconds of pressing button #1 to arm the system, the shock sensor will be bypassed
until the next arming of the system.
Manual Arming
To arm the system without the remote the operation is as follows:
- With the system disarmed
- The ignition is off
- Press the valet switch for 3 seconds
- Hazard lights flash once and LED will flash rapidly
- 30 seconds later, the system will be armed automatically but the doors will not be locked
04. Programming a new Remote Control
- Start with the system disarmed
- Turn the ignition on
- Within 10 seconds press valet switch 3 times
- After 2 seconds the siren will sound for 2 secs to confirm the system is now in code learning mode
- Within 10 seconds press any key of the remote control, the siren will sound for 1 sec and the hazard lights will
flash twice to confirm the remote control has been programmed to the system. All the previous codes in the
system will be erased entirely so you must now program your second remote control.
- Within the next 10 secs press any key of 2
nd
remote control to program the 2
nd
remote control to the system, the
siren will sound for 1sec and hazard lights flash twice to confirm.
- The system will leave the code learning mode automatically after programming the 2 remote control to the system
and the siren will sound for 2 seconds
to confirm.
- The system will leave the code learning mode at any time if the ignition off is turned off.
- The system will leave the code learning mode if a remote control button is not pressed within 10 secs.
