Floor Stand
Carton contains
2.1.3 Floor Stand Assembly Instructions
a) Lay the two end supports (A & D) on their backs on
the floor. Slip the bottom shelf (E) over the cross
bars and secure through the side flanges into the
holes in the cross bar.
b) Slip the shelf (C) between the vertical tubes and
secure through the flanges into the holes in the
inside of the tubes.
c) Raise the partly assembled stand on to its feet and
from the rear, place the two back skirts (B)
between the rear using the nuts and bolts provided.
d) Lift the grill and position it carefully on top of the
assembled stand. Secure in position through the
two holes in the centre of the upper panel (F).
Wall Bracket
Carton contains -
Figure 3
The installer must make
sure that the wall on
which the grill is tobe
mounted is suitable to
carry the unit weight and
can be suitably plugged
t o t a k e
N o
.
8
w o o d s c r e w s o f a
minimum length.
Using the shelf as a
template, hold it against
the wall at the required
h e i g h t .
W h i l s t
maintaining the top
surface horizontal, mark
fixing screw positions.
Remove the shelf and
d r i l l t h e w a l l t o
accomodate suitable
plugs for No. 8 screws.
Firmly secure the shelf in
position.
Place the grill on the
shelf and place screws
through holes numbered
6 to corresponding holes
in the frame of the grill.
2.1.5 Assembly of Support Bars and Plaques
a) Remove the enamelled facia by undoing the fixings
which secure it at the bottom edge. Ease the panel
forward at the bottom and lift it clear of the hidden
location screws.
b) Remove the top panel by undoing the two fixings at
the rear and slide the panel backward, clear of the
front location.
c) Remove the inner top panel to expose the burners.
d) Place the cast iron support bars between the
burner and the front and rear locating slots. Insert
the bars with the lugs facing upwards. This will
enable the plaques to be held in position against
the burner, see Figure 4.
A - LH Support
(1 off)
B - Back Skirt
(2 off)
C - Top Shelf
(1 off)
D - RH Support
(1 off)
E - Bottom Shelf
(1 off)
F - Upper Panel
(1 off)
G - Adjustable Feet
(4 off)
and the following fixings - M5 x 10mm Hex Screws (22 off), M5 Hex Nuts (4 off)
and M5 Shakeproof Washers (18 off)
Figure 2
Bracket and screwpack.
Note - Rawlplugs and woodscrews are NOT
supplied
2.1.4 Wall Bracket Mounting Instructions
