Falcon Elan U109645 - 02, Installation & Service Instructions Manual

Page: 27 / 32

27 U109645
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Australia
Fit the new fan and reassemble in reverse order. Check the
operation of the oven.
20. To Replace an Oven element Thermal Cutout
Pull the cooker forward to gain access to the cover box. Undo
the cover screws and lift clear. The cutout is located on the
earth plate beside the oven element connections. Disconnect
the cutout wiring, undo the fixings that secure the cutout to
the earth plate, and remove.
Fit the replacement cutout and re-assemble in reverse order.
21. To Remove the Left hand Oven Bottom and Top
Elements
Bottom Element
Pull the cooker forward to access the cover boxes at the rear of
the unit. Remove the fixings that secure the cover and lift it clear.
Remove the two screws ‘A’ and allow the plate to drop down:
Remove the two screws 'B' holding the element to the bottom
sheet:
Disconnect the leads, noting their positions.
Withdraw the bottom element. Fit the new element and re-
assemble in reverse order.
Top Element
Open the left hand oven door and undo the fixings that secure
the heat shield. Remove the top element bracket fixings and
withdraw the element. Replace the element and re-assemble in
reverse order.
Check that the oven operates satisfactorily.
22. To Adjust the Main Oven Door Angle
The Main Oven door bottom hinge can be adjusted to alter the
angle of the door. Loosen the bottom hinge fixing screws and
use the notch and flat-bladed screwdriver to move the position
of the hinge to set the hinge position.
Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity