SECTION 1 - GENERAL DESCRIPTION
The oven interior is enamelled. The fan pulls air from
oven chamber through a centre hole to pass over heating
elements that surround fan. This blows back into
chamber at top and bottom of rear panel.
A smell may be noticeable when oven is used for the first
time. This will disappear after a few hours.
SECTION 2 - CONTROLS and OPERATION
CONTROLS (Refer to Figure 1)
A. Heat On Indicator Neon
This lamp will glow when oven is heating to set
temperature.
B. Temperature Control/Fan Switch
This control allows an oven temperature to be set
between 50° and 270°C.
C. On/Off Switch
Turns power to the unit on and off.
D. Timer
This is a countdown clock with up to 120 minutes
(2 hours) operation or manual operation.
E. Oven Light Switch
Oven lamp will light when button is pressed down.
F. Limit Device Reset Button
150mm behind control panel on base panel.
SECTION 3 - OPERATION
3.1 CONNECT TO POWER
Ensure oven is connected to electrical power supply.
3.2 SWITCHING ON
Press on/off switch (C) down to turn oven fan on.
Turn timer knob (D) to desired setting, anti-clockwise for
manual setting or turn clockwise to required timed
setting.
Turn temperature control knob (B) and heat indicator
lamp (A) will glow to signal that heat is required. This will
go out when set oven temperature has been reached.
3.3 SWITCHING OFF
Turn temperature control knob (B) fully anti-clockwise to
0 position when oven is not in use. Turn off switch (C).
A
B
C
D
E
Figure 1
F
Figure 2