SECTION 5 - TROUBLESHOOTING
If a fault occurs during use, an error code will be
displayed in a series of flashes.
These correspond to the numbers in the code column of
the following table.
For example, 6 short flashes followed by an extended
flash would indicate error code 06
(Generator internal
temperature too high).
The codes are provided to diagnose possible faults and
the action required to remedy any such condition.
Note: Most faults can be rectified by simply
switching the unit off for 10 seconds. After this time,
turn the power back on at mains supply.
If the fault continues to occur after this action then
please refer to the table. This will provide the
solution to rectify the condition.
SUPPLY PROTECTION DEVICE
The appliance is fitted with a miniature circuit breaker
(MCB)
as additional protection against over current.
If unit fails to operate or show any operational indicators,
Follow details in Error Code Table before calling a
service engineer. The symptoms may indicate a failed
induction generator.
ERROR CODE TABLE
If any fault occurs during use, an error code
corresponding to the details in the table will be displayed
as a series of flashes.
For example, 6 short flashes followed by a long flash
would indicate error code 06.
The codes will help determine unit faults and the table
lists actions required to remedy any such fault.
Note
: most errors will be rectified by switching unit off at
mains supply for 10 seconds and switching supply back
on.