2.4 INSTRUCTION TO USER
After installation and commissioning is completed, please
hand User Instructions to user and ensure that the
person
(s)
responsible understand the instructions
regarding correct operation and cleaning of the appliance.
Particular emphasis should be given to:
● suitable pan type,
● Regular cleaning of air filter.
● Keeping cooking zone suface free from all objects,
particularly metal utensils, at all times.
The user must also be made aware of potential to heat
jewllery and to disrupt electronic equipment placed over
the cooking zones.
SECTION 3 -
SERVICING AND CONVERSION
BEFORE ATTEMPTING ANY MAINTENANCE, ISOLATE
THE APPLIANCE AT THE MAINS ISOLATING SWITCH
AND TAKE STEPS TO ENSURE THAT IT CANNOT BE
INADVERTENTLY SWITCHED ON.
3.1 CONTROL PANEL
Remove fixings from below hob.
Release fixings from below control panel.
Pull panel slightly forward from below and allow it to slide
down until clear.
3.2 MAINS ACCESS PANEL
(at Rear)
Remove fixings that secure access panel to rear.
Replace in reverse order.
3.3 REMOVING THE GENERATOR
Remove fixings from glass hob
(2 front / 2 back)
.
Carefully remove glass hob assembly.
Remove fixings
(3 per side)
along top sides of generator/
coil assembly.
Carefully raise generator/coil assembly and rest this on a
suitable support.
Disconnect all generator wires, note connection locations.
Remove generator assembly.
Replace in reverse order.
3.4 REPLACING CONTROL / LED INDICATORS
Remove control panel as detailed in Section 3.1.
Note
: Indicators are polarity driven. Green cable (-)
connects to spade terminal beside LED body flat side.
Remove two wires connected to LED.
Remove control knob.
Undo fixings that secure control to panel.
Remove associated LED
(if required
).
Remove main access panel as detailed in Section 3.2.
Unplug cables at rear of switch.
Ensure that replacement switch DIL settings are as per
those of removed switch. Refer to wiring diagram on
Page 8.
Replace switch and re-assemble in reverse order.
3.5 CERAMIC HOB ASSEMBLY
Remove control panel as detailed in Section 3.1.
Remove 2 fixings that secure hob at front.
Remove 2 fixings that secure hob to rear panel.
Carefully lift and remove top frame/glass-ceramic plate
assembly, and lay on a flat surface.
If replacing hob in the event of glass damage, ensure any
glass debris is cleared away from induction coils and from
inside of unit.
Ensure that no coil spacers have been removed or
disturbed when removing the glass panel. If this is so,
then they must be restored to their locations.
Replace in reverse order.
3.6 INDUCTION COIL ASSEMBLY
Warning
DO NOT USE THE UNIT IF THE CERAMIC TOP IS
CHIPPED, CRACKED OR BROKEN. THE PANEL
NEEDS TO BE REPLACED!
Remove control panel as detailed in Section 3.1.
Remove ceramic hob assembly as detailed in
Section 3.5.
Trace coil cable to rear of generator. Insert screwdriver
into spring-loaded green terminal below each cable
(black or white)
. Raise handle enough to release cable.
DO NOT FORCE. DAMAGE CAUSED BY EXCESSIVE
FORCE IS NOT COVERED BY WARRANTY!
Remove 2 thermocouple cables
(red)
from smaller green
terminal block. Push small green post below each cable.
Remove fixings at top corners of faulty coil assembly.
Take care to catch spacer and spring as screw is
released.
The coil assembly can now be removed.
4
Summary of Contents for E3901i
Page 10: ...10...
