WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
30
ArtNo.215-0013 - 90 Elan DF - Removing the control panel
��
0
0
0
0
Check in the
‘Technical Data’
section at the back of these
instructions that the cooker is convertible to the type of
gas you want to use.
This conversion must be performed by a competent person,
in accordance with these instructions and with the local
supply company requirements.
Failure to convert the appliance correctly could invalidate any
warranty or liability claims and lead to prosecution.
The conversion instructions must be used in conjunction
with the rest of the appliance instruction, in particular for
information on Standards, cooker positioning, connection,
hose suitability, etc.
When servicing or replacing gas-carrying components,
disconnect from the gas before starting, and check that the
appliance is gas sound after completion.
DO NOT use reconditioned or unauthorised gas controls.
Disconnect from the electricity supply before
conversion. Before electrical reconnection, check
that the appliance is electrically safe.
Injectors
Remove the burner caps and heads. Remove the old jets.
Fit the new jets: see
‘Technical Data’
section for correct jets.
Reassemble in the reverse order
(Fig.8-1)
.
Tap Adjustment
Disconnect from the electricity supply.
Remove all control knobs. Remove the handrail (if fitted).
Remove the two plastic blanking plugs, followed by the two
end bracket fixing screws.
Remove the two cross-head screws hidden by the two end
bracket fixing screws.
Open the oven door and grill door. Undo the 2 screws on the
underneath of the control panel
(Fig.8-2)
. The control panel
should drop down slightly. It is held at each end by two holes
in the top edge that locate on the tags on the inner panel
(Fig.8-2)
.
Lift the control panel clear of the tags and pull the control
panel forward.
Take care not to damage or strain the wiring.
To Convert to Propane Gas
Using a pair of long nosed pliers, carefully remove the bypass
screw and fit the correct replacement screw
(Fig.8-3)
; see
‘Technical Data’
for the correct size. Tighten the screw down.
Refit the control panel.
8. Conversion to Propane Gas
�
�
�
ArtNo.311-0010 Injectors
Fig.8-1
A - Jet, B - Internal injector, C - External injector
ArtNo.102-0015 - Soudillon tap bypass screw
�
Fig.8-3
Fig.8-2
A - Tap bypass screw
DocNo.080-0002 - LP gas conversion - 90 elan
