INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
25
ArtNo.010-0004 Moving the cooker
ArtNo.010-0002 Rear roller nut
ArtNo.010-0010 Lowering the rear rollers (90)
x10
Fig.7-8
Fig.7-6
Fig.7-7
ArtNo.010-0009 Pushing the cooker
Fig.7-9
ArtNo.342-0002 - Elan - drawer position
Fig.7-5
Lift up the ends of the plastic clips (one each side) to release
the catches holding the drawer to the side runners and at the
same time pull the drawer forward and away from the side
runners
(Fig.7-5)
.
For safety’s sake push the drawer runners back out of the
way. Put the drawer somewhere safe - do not refit it until the
installation is complete.
First fit the levelling tool on the hexagonal adjusting nut
(Fig.7-6)
.
Make 10 complete (360º) turns clockwise
(Fig.7-7) -
this
means turning and removing the levelling tool 20 times.
Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the cooker.
Completing the Move
Unfold the rear edge of the pack base tray. Grip the fascia
panel and lift the front of the cooker slightly
(Fig.7-8)
.
Carefully push the cooker backwards off the pack base.
Remove the pack base. Position the cooker close to its final
position, leaving just enough space to get behind it
(Fig.7-9)
.
DO NOT use the control knobs to manoeuvre the
cooker.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker. To adjust the height of the rear of the cooker use the
levelling tool supplied to turn the adjusting nuts at the front
bottom corners of the cooker. To set the front feet turn the
bases to raise or lower.
Leave the levelling tool in the storage drawer, so that the
customer can use it if they wish to move the cooker.
