INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
17
Checking the Parts:
Location of Cooker
The cooker may be installed in a kitchen/kitchen diner but
NOT in a room containing a bath or shower.
Note:
An appliance for use on LPG must not be installed
in a room or internal space below ground level, e.g. in a
basement.
Conversion
This appliance is supplied as G 20 20 millibar.
A conversion kit for other gases is included with the
appliance. See the instructions that are supplied with the
conversion kit.
After converting the appliance, please attach the Gas
Conversion sticker over the appropriate area of the data
badge – this will identify the gas type for which the appliance
is now set.
You will need the following equipment to complete the
cooker installation satisfactorily:
•
Stability bracket: If the cooker is to be supplied with gas
through a flexible hose, a stability bracket or chain must
be fitted.
These are not supplied by with the cooker but are
available at most builders’ merchants.
•
Gas pressure tester/manometer
•
Flexible gas hose: Must be in accordance with the
relevant standards.
•
Multimeter: For electrical checks
You will also need the following tools:
1.
Electric drill
2.
Masonry drill bit (only required if fitting the cooker on a
stone or concrete floor)
3.
Wall plugs (only required if fitting the cooker on a stone
or concrete floor)
4.
Steel tape measure
5.
Cross head screwdriver
6.
Flat head screwdriver
7.
4mm & 3mm Allen keys
8.
Spirit level
9.
Pencil
10. Adjustable spanner
11. Screws for fitting stability bracket
Levelling tool & Allen keys
Full capacity shelf
ArtNo.000-0002 Classic tools
ArtNo.326-0013 - Full capacity shelf
(Falcon)
Grill pan tray support
2 grill pans & trivets
ArtNo.326-0004 - Cradle shelf
ArtNo.331-0008 - 90SC
grill pan & trivet
3 energy saving shelves
Divider
ArtNo.326-0002 - Energy saving shelf
ArtNo.281-0028 - Albertine divider
Plinth
ArtNo.350-0008 - 90 SC plinth
