16
To refit the side support, first
locate the tag at the bottom
of the support in the slot in
the locating bracket in the
oven side.
Then locate the tops of the
side arms in the holes at the
top.
The panels on the oven sides are fixed and
cannot be removed. They have been coated
with special enamel that partly cleans itself.
This does not stop all marks on the lining, but
helps to reduce the amount of manual cleaning
needed.
The Cook & Clean panels work better above
200°C. If you do most of your cooking below
this temperature, occasionally remove the shelf
supports and wipe the panels with a lint free
cloth and hot soapy water. The panels should
then be dried and the oven heated at 200°C
for about one hour. This will ensure the Cook &
Clean panels are working effectively.
Don’t use steel wool (or any other materials
that will scratch the surface). Don’t use oven
cleaning pads.
Moving your cooker
Switch off the electricity supply.
The cooker is heavy; two people may be
required to move it.
The cooker is fitted with one roller at the front
and two at the back. There are also two screws
down levelling feet at the front.
The front roller, designed for moving the
cooker, can be wound down. The levelling
tool that controls this roller should be in the
storage drawer compartment. If you cannot
find the levelling tool, contact your installer.
See the start of the ‘Installation’ section of these
instructions where they should have entered
their details.
To remove the drawer
Pull the drawer forward.
Lift up the ends of
the plastic clips (one each side) to release the
catches holding the drawer to the side runners
and at the same time pull the drawer forward
and away from the side runners.
For safety’s sake push the drawer runners back
out of the way.
Locate the tool as shown.
Turn the levelling tool clockwise, two full (180°)
turns. It will be stiff. The front of the oven will
rise slightly as the roller drops down.
Open the grill door and right hand oven door
so that you can get a good grip on the bottom
of the fascia panel as you move the oven.
Do not move the oven by pulling the handrail,
door handles or knobs.
Move the oven a bit at a time, checking behind
it to make sure the gas hose is not caught.
Make sure both electricity and gas cables have
sufficient slack to move the cooker forward as
you go along.
If a stability chain is fitted, release it as you
ease the cooker out.
When you replace the cooker, wind it down off
the rollers by turning the levelling tool anti-
clockwise. This is important. It will stop the
cooker moving accidentally, while in use.
Summary of Contents for 1092 Deluxe Dual Fuel
Page 36: ......
