22
The hose should be fitted so that both inlet and
outlet connections are vertical so that the hose hangs
downwards in a ‘U’ shape.
For Natural Gas the flexible hose must be in accordance
with B.S.669.
For LP Gas it should be capable of 50mbar pressure, 70C
temperature rise and carry a red stripe, band or label.
If in doubt contact, your supplier.
Screw connect the threaded end of the hose into the gas
inlet in the underside of the connector block on the back
of the cooker.
After completing the gas connection, check the cooker
is gas sound with a pressure test. When checking for gas
leaks do not use washing up liquid - this can corrode.
Use a product specifically manufactured for leak
detection.
Pressure testing
The gas pressure can be measured at the pressure test
point next to the gas inlet. Turn and light one of the
hotplate burners.
For Natural Gas the pressure should be 20mbar.
For Propane the pressure should be 37mbar.
For Butane the pressure should be 28-30mb.
Reassemble burner top, making sure it is reassembled in
the correct way on the burner body.
Electrical Connection
This appliance must be installed by a qualified electrician
to comply with the relevant regulations and also the
local electricity supply company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note
The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker,
through a suitable cooker control unit incorporating
a double pole switch having a contact separation
of at least 3mm in all poles. This cooker must not be
connected to an ordinary domestic power point.
The total electrical load of the appliance is approximately
7.4kW. The cable size used should be suitable for this
load and comply with all local requirements. Access to
the mains terminal is gained by removing the electrical
terminal cover box on the back panel. Remove the oven
vent cover panel first - see “Gas connection illustration”.
Connect the mains cable to the correct terminals for your
electrical supply type.
Check that the links are correctly fitted and
that the terminal screws are tight.
Secure the mains cable using the cable clamp.
Hotplate
Check each burner in turn. There is a flame safety device
that stops the flow of gas to the burner if the flame goes
out. There is also a spark ignition system that works
when the knob is pressed in.
For each burner, push in and turn the knob to the closed
flame symbol ( ).
The igniter should spark and light the gas. Keep holding
the knob pressed in to let the gas through to the burner
for few seconds.
If, when you let go of the control knob, the burner goes
out, the safety device has not held in. Turn the control to
the off position and wait one minute, then try again this
time holding in the control knob for slightly longer.
Grill
Open the grill compartment door. Turn on the grill
control and check that the grill heats up.
Oven check
Turn on the ovens and check that they start to heat up.
Turn off the ovens.
Fitting the plinth
Remove the 3 screws along the front bottom edge of the
cooker. Find the matching colour screws in the serperate
pack and fit.
