C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
-
V
ERSION
1.0.0
Parameter description
<type>
It defines under which conditions the MAMBOII device should be woken up. The
value can be set to.
Value
Meaning
IGN
Puts the system into IGN-SLEEP mode until the
BTN1
(
right-
button on MAMBOII
)
is short pressed (see chapter
.
This SLEEP mode permanently blocks the serial interface
(Bluetooth), closes the available TCP line, detaches the
MAMBOII from the GPRS and deregisters it form GSM
network. To switch the unit to normal operation, press short
the
BTN1
.
Motion
Puts the system into MOTION-SLEEP mode until motion is
detected (
attempts to move it in any direction, either up or
down, or left or right)
. MOTION-SLEEP mode permanently
blocks the serial interface (Bluetooth), closes the available
TCP line, detaches the MAMBOII from the GPRS and
deregisters it form GSM network. A
ttempts to move it in any
direction
switch the MOTION-SLEEP mode off and take the
MAMBOII device back to full functionality. It uses the use
the same filter parameter as
MOTION.FILTER.
Ring
Puts the system into RING-SLEEP mode until an incoming
call or an SMS message arrives. This SLEEP mode
permanently blocks the serial interface (Bluetooth), closes
the available TCP line and detaches the MAMBOII from
the GPRS services. Only GSM engine remains powered
and GSM-registered (for detecting incoming calls and
SMS). The major benefit of RING-SLEEP mode is that the
MAMBOII remains accessible via GSM services such as
SMS, voice or data call. The first incoming ring terminates
the RING-SLEEP mode, hangs up that call, ri-initializes the
GSM engine and takes the MAMBOII device back to full
functionality.
Please note that,
the MAMBOII could not be
put into the RING-SLEEP mode if it is not GSM registered.
Blocking the Bluetooth serial line signifies the sleep mode
activation. All PFAL commands sent within the SMS
contents will be executed after the GSM has been ri-
initialized.
Timer=
<
Puts the system into TIMER-SLEEP mode until the timer
expires. The period of time the MAMBOII device stays in
the TIMER-SLEEP mode can be defined in the timeout
entry. TIMER-SLEEP mode permanently blocks the
Bluetooth serial interface, closes the available TCP line,
detaches the MAMBOII from the GPRS services and
deregisters it form GSM network. The system will be woken
up again when the timer expires. The time expiration
switches the TIMER-SLEEP mode off and takes the
MAMBOII device back to full functionality.
Note: Do not use the TIMER-SLEEP parameter alone. It is
recommanded to combine it with the IGN-SLEEP
parameter.
<
timeout
>
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 40 of 271
