C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
-
V
ERSION
1.0.0
3.2.20 GSM parameters
3.2.20.1 GSM.PIN
Parameter syntax
The parameter lets the MAMBOII device store the entered PIN
<
new_pin
>
of the
used SIM card.
<new_pin>
It specifies the PIN number of the used SIM card. This may be for example the SIM
PIN to register onto the GSM network, or the SIM PIN to replace the current PIN
number with a new one.
How to set/get GSM configuration:
Set configuration
$PFAL,Cnf.Set,GSM.PIN=1321
Get configuration
$PFAL,Cnf.Get,GSM.PIN
Notes
•
Successful PIN authentication only confirms that the entered PIN was
recognized and correct. The PIN acception does not necessarily imply that
the MAMBOII is registered to the desired network. Typical example: PIN was
entered and accepted, but the MAMBOII fails to register to the network. This
may be due to missing network coverage, denied network access with
currently used SIM card, no valid roaming agreement between home
network and currently available operators etc.
•
To verify the present status of network registration, please refer to the LED
states in the hardware manual of the MAMBOII device. The next way to verify
if it is available, establish remotely a voice or data call.
•
No PIN request is more pending, if the PIN number of used SIM card once has
been specified and it is sent to the MAMBOII device. The MAMBOII stores that
specified PIN and uses it upon request of the GSM part. No more PIN entry is
required from your side, as long as the used SIM card is not replaced with a
new one.
•
A PIN message sent without value deletes the existent entry.
3.2.20.2 GSM.CALLID.EN
Parameter syntax
GSM.CALLID.EN=<
It configures the caller identification. It provides an intelligent network service that
transmits the caller's phone number to the called party's phone during the ringing
signal before the call is answered. This feature allows you to identify incoming calls
for accepting or rejecting them by using the call events accordingly. This
parameter refers to the GSM supplementary services CLIP (Calling Line
Identification Presentation) and CLIR (Calling Line Identification Restriction). The
CLIP service enables a called subscriber to get the calling line identity (CLI) of the
calling party. The CLIR service determines whether your participant will see your
phone number or not.
<
enable
>
It allows you to enable and disable the caller identification. Following values can
be set:
Value
Meaning
0
Disables caller identification (CLIP + CLIR)
1
Enables caller identification (CLIP + CLIR)
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 176 of 271
