GPS-RECEIVER JP7-T
VERSION 1.02
0.2 Scope of the user’s manual
This document describes the hardware interface and the technical
specifications of the JP7-T.
It is also the preliminary data sheet for the electrical and mechanical device
application design.
As far as JP7-T family concept is concerned, there are three different JP7-T
GPS Receiver Modules available. The difference between these receivers
can be recognised by looking on the bottom side of the module (see attached
picture on the chapter 0.5 “
Order option
”).
To choose a unit it depends on the customer requirements:
JP7-T
JP7-TB
JP7-TC-1
JP7-TC-2
RF Part
TCXO
25.5535 MHz 25.5535 MHz
25.5535 MHz
25.5535 MHz
Active
antenna power
control
built in
built in
built in
built in
RF connector Not available Not available
U.FL-R-SMT –
plug antenna
connector from
Hirose.
No RF
connector.
Solder pads, only
Digital Part
Connector
Not available Not available
50-pin, Hirose
DF12C, Board-To-
Board connector
50-pin, Hirose
DF12C, Board-
To-Board
connector
Balls
Not available
48-Balls are
available
Not available
Not available
In this manual user will not find separately description for each option of
devices. The interfaces, pin-out and some application’s example are the
same for all devices.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 6
