4.6 Additional functions
4.6.1 Configuring the Z-Wave network using the ZWMP weather module (INCLUDE function).
Adding a device to the “Z-Wave” network is possibly only with the use of PRIMARY controller
(e.g. keyboard ZWK15, ZWK1, ZWP15, ZWPTV). The ZWMP module should be associated with the network
as SECONDARY. However, there is a possibility of programming the module for the network as PRIMARY.
The procedure of device adding to the network with the use of the ZWMP module is presented in
Figure 7.
*) Programming error results from the fact of not receiving any response from the device and may be caused
by:
•
failure to press the programming button within 10 seconds from the module signalling its readiness for
adding the device to the network;
•
long distance between the module and the device being added;
•
the module has been earlier associated with the network as SECONDARY – it is necessary to perform
DEFAULT procedure.
11.09.21 NC815
10/16
©2011,
FAKRO
Figure 7: Removing device from the Z-Wave network using ZWMP weather module
4
. The controller is signaling that the
device has been successfully
associated with the network (two
LEDs on for app. 2-3 sec.). For
operating accessories with the use of
the module, proceed to section 4.2.
5*
. Programming error – LEDs
flashing for app. 2-3 sec.
2
. The controller is signaling its
readiness for adding a new device
to the network (two external
LEDs on for 10 sec.).
3. Press “P” button on the device and
hold it for 0.5 sec. (see Device
Programming Manual).
1
. Press “
In/Ex
” button once.
O
C
Sel
In/Ex
4
3
2
1
x1
O
C
Sel
In/Ex
4
3
2
1
O
C
Sel
In/Ex
4
3
2
1
O
C
Sel
In/Ex
4
3
2
1
x1
Summary of Contents for ZWMP
Page 13: ...11 09 21 NC815 13 16 2011 FAKRO ...
Page 14: ...11 09 21 NC815 14 16 2011 FAKRO ...
