11/16
11/16
1
2 3
4
x1
Cooperation of devices from different manufacturers in Z-Wave network
Z-Wave allows to integrate devices of different manufacturers which can work in different
groups; lighting, heating, domestic automation etc. Z-Wave devices operate as repeaters in the
network, thus increasing the range of radio communication. The more devices in the network,
the more reliable and more resistant to interference is performance of the devices within the
network.
Adding the AMZ Solar awning blind to the network operated by the controller of other
manufacturer.
Note!!!
Make sure that the device (awning blind) is not a part of any network.
Start the INCLUDE procedure by means of the controller of the existing network and then
press the “Programming” button on the awning blind being added to the network.
Note: Information on how to initiate and perform the INCLUDE and ASSOCIATE functions with
the use of controllers of other manufacturers is to be found in the manuals of these devices.
Special function – ALL ON, ALL OFF
It is possible to define whether the awning blind has to obey CLOSE ALL and OPEN ALL
commands.
Note: Instructions on how to define CLOSE ALL and OPEN ALL functions can be found in the
manuals of these devices.
Manual operating
The manual operating button makes it possible to operate the AMZ Z-Wave Solar awning
blind right after its installation. In order to control the awning blind manually, it is necessary to
press the manual operating button. Buttons operate in the sequential cycle:
1 . First pressing of the button causes the awning blind to unroll.
2. Second pressing of the button stops the awning blind.
3. Third pressing of the button causes the awning blind to roll up.
Additional information
