Operation
14
Fig. 10
Place the virtual barrier at the same level on the
surface where you are going to use the robot vacuum.
Fix the virtual barrier against the wall.
Place the virtual barrier and the charging station
at a distance of more than 3 m apart, to prevent inter-
ferences.
Do not place the charging station within range of
the virtual barrier’s signal.
1.
Make sure that the batteries are not discharged.
2.
Position the virtual barrier so that it blocks the area
you do not want the robot vacuum to enter (
Fig. 10
).
3.
Remove any objects that may be in front of the
virtual barrier, to prevent its inadequate operation.
4.
Turn on the virtual barrier with switch
2
5.
Check that the robot vacuum cannot cross the
boundary created by the virtual barrier.
6.
Set off the switch
2
, when the virtual barrier is not
required
.
NOTICE!
Some differences may occur in the direction of the
virtual barrier’s infrared signal and the robot's reception
range, due to the movement of the robot during while
in use. This difference may vary depending on the
work environment and the charging level of the
robot and the virtual barrier.
It is also possible to use an additional virtual barrier.
(see page 27)
