26
3.5.2 S
TANDARD
C
ONNECTIONS
- O
UTPUTS
NAME
DESCRIPTION
LOCATION
DESTINATION
SPEAKER 1A
Feed for Speaker 1
EDAC 8
Main Monitor amplifier L
SPEAKER 2A
Feed for Speaker 2
EDAC 8
Main Monitor amplifier R
SPEAKER 3
Feed for Speaker 3
EDAC 8
Main Monitor amplifier C
SPEAKER 4
Feed for Speaker 4
EDAC 8
Main Monitor amplifier Surround (LCRS
Mode)
Main Monitor amplifier Sub (5.1 Mode)
SPEAKER 5
Feed for Speaker 5
EDAC 8
Main Monitor amplifier Surround L
SPEAKER 6
Feed for Speaker 6
EDAC 8
Main Monitor amplifier Surround R
SPEAKER 7
Feed for Studio Speaker LEFT
EDAC 8
Studio Speaker or headphones amplifier
L
SPEAKER 8
As above, Studio Speaker
RIGHT
EDAC 8
Studio Speaker or headphones amplifier
R
Meter O/P 1
Meter feed from speaker path
1. NOTE signal is
UNBALANCED, -6dB.
EDAC 8
Customer supplied external meters.
These meters will meter whatever is
switched to the main monitors, and are
switchable PRE DOLBY, POST DOLBY,
POST MONO or POST Monitor Pot.
Meter O/P 2
As above, speaker 2
EDAC 8
As above
Meter O/P 3
As above, speaker 3
EDAC 8
As above
Meter O/P 4
As above, speaker 4
EDAC 8
As above
Meter O/P 5
As above, speaker 5
EDAC 8
As above
Meter O/P 6
As above, speaker 6
EDAC 8
As above
Meter O/P 7
as above, Studio Speaker L.
EDAC 8
As above, but will meter Studio speaker
selection
Meter O/P 8
As above, Studio Speaker R.
EDAC 8
As above.
SPEAKER 1B
Pressing the "Near" monitor
button on FAME causes the
monitor box to become stereo,
and Speaker Path 1 to be
routed to this output via a
relay.
EDAC 8
Stereo Nearfield speaker amplifier L
SPEAKER 2B
As above, Speaker Path 2
EDAC 8
As above, R.
The Monitor Box is controlled by FAME 2 via the 25 way D- Type Male Connector to 9 Way
Male D-Type Connector cable, and must have its front panel ID set to 2. This is achieved by
inserting a thin pointer into the small hole on the front panel and pressing the concealed
switch there repeatedly until the numeral "2" is displayed on the front panel indicator. The
unit must be switched on to achieve this, and the setting is remembered until a full reset or
software download.
Audio connections are made via 4 x 56 way EDAC connectors.
Wiring details and a Monitor schematic showing signal flow can be found in the appendix
at the back of this manual.
Summary of Contents for Fame 2
