Fair Light Fame 2, User Manual, Page: 22 / 75

22
3.3 I
NSTALLING THE
F
AME
2 C
ONSOLE
There are 3 frame sizes available for the console in Standalone version only. These are:
n
48 Fader
n
40 Fader
n
32 Fader
There are 3 frame sizes available for the console in Standalone or Drop Through versions.
These are:
n
24 Fader
n
16 Fader
n
8 Fader
The drop through frame has been designed to allow a custom made frame to be built
around the console. It is advised that the custom furniture be completed prior to delivery of
the Fame 2 Console. Although the ‘drop through’ console can be supported on a flat surface as
a temporary measure until installation is complete.
At least four people are required to lift a 24 fader Standalone Fame console. When lifting
the console care should be taken to avoid damage to the protruding TFT display.
C
ONNECTING
T
HE
V
ARIOUS
F
AME
2 C
OMPONENTS
1. Position the console to allow access to the rear connector panel beneath the TFT
display.
2. Locate the PC, Matrix and Surround Monitor Units, with their associated power and
control cables :-
•
1 of 25 way round ribbon cable -Surface control
•
1 of 9 pin D type F/M to 9 pin Male D type -Touch Screen Control
•
1 of H D - 15 Male to Female connector with 44 way adaptors -TFT Display
•
1 of 25 way male D type to 9 way male D type - X-Point control
•
1 of 9 way male D type to 9 way male D type -X-Point to Surround intercon-
nect cable
3. Before making any cable connections, ensure that power is disconnected from all
equipment. This will prevent electrical damage to components within the equip-
ment.
4. The PC should be mounted at a maximum distance of 10 meters from the rear
connector panel on the console - This length is governed by the TFT display cable.