13
Troubleshooting
Note: if all solutions given above don’t work for you, please take actions below:
1) Re-set the robot by toggling the power switch on bottom side of the robot.
2) If re-set action doesn’t work, please send the robot to seller for repairing.
Problem
Possible Cause
Solution
1
Robot suddenly stops
cleaning and indicator
stays in blue
1. Robot was picked up
1. Re-place the robot on the floor and re-start the robot
2
Power on robot, its
indicator is in blue
1. Cliff sensor fault
1. Clean cliff sensor
2. If solutions given above doesn’t work, send it to the
seller for repairing
3
Robot does not change
direction when it comes
up against obstacle
1. Bumper sensor fault
1.Check the sensor to see if it is covered by any object
4
During charging, LED
indicator flashes in red
and robot beeps
1. Robot switch might not
powered on
1. Switch on the robot
5
LED indicator flashes in
red
1. Battery low
1. Fully charge the battery
6
Blue LED flashes once,
Red LED flashes once.
1. Side brush get stuck
1. Put robot on flat surface and clean side brush
7
Blue LED flashes once,
Red LED flashes twice.
1. Robot bumper is not
flexible enough
1. Loosen half circle of bumper bottom screw
8
Blue LED flashes once,
Red LED flashes triple.
1. Robot wheel get stuck 1. Check wheels and take out the foreign object
