10
Product Operation
Cleaning modes
1. Auto cleaning
In this mode, the robot will clean a room automatically and adjust its
cleaning mode according to the environment.
Note:
In standby mode, press ON/OFF button on remote control or CLEAN
button on robot to start auto cleaning.
2. Spot cleaning
Press SPOT on the remote controller to start spot cleaning.
Note:
A. It is suggested that users could select spot cleaning mode
when robot cleans around the areas with much dust/dirt.
B. When robot is in standby, press SPOT, robot will clean for
around 30S or until the robot hits an obstacle and stop.
C. During robot cleaning, press SPOT, around 30S spot
Cleaning(or until the robot hits an obstacle), robot will then
turn to other cleaning mode.
3. Edge cleaning mode
Switch on the robot, press MODE on the remote control and select
edge cleaning. Under edge cleaning mode, the robot will do
cleaning along the obstacle by its side brushes.
4. Zig –Zag cleaning mode
Robot will automatically goes into zig-zag cleaning when it detected it’s in an open area or the
environment with less obstacles. Or you can press MODE on remote control and Select zig-zag cleaning.
Note:
A. After switch on the robot, by press MODE on the remote control,
user can select different cleaning modes. And user can
press ON/OFF button to stop it.
B. Mode1 for spiral cleaning, mode 2 for auto cleaning
mode 3 for edge cleaning, mode 4 for zig-zag cleaning
