1/ INSTALLING YOUR APPLIANCE
•
CHOICE OF LOCATION
Your appliance must be flush fitted into a
support cabinet surface which is at least 3 cm
thick and is manufactured from heat resistant
material or covered in a heat resistant
coating.
A minimum distance of 30 cm either side of
the hob should be free from any obstructions
(cabinet or panel) which could hinder safe
handling of cooking utensils.
If a horizontal divider wall is positioned under
the hob, it must be located between 10 cm and
15 cm from the top of the work surface. In any
event, do not store aerosol cans or
pressurised containers in any compartments
located under the hob (refer to the
“
Safety
Recommendations
”
) chapter.
FITTING
In order to guarantee the seal between the
hob and the work top, the supplied seal must
be glued into the insert prior to hob
installation:
Refer to the diagram
(Fig. 01)
.
—
Remove the pan supports, burner covers
and burner heads; noting their positions.
— Turn the hob over and carefully place it on
top of the opening in the cabinet to prevent
damage to the knobs and spark plugs.
— In order to guarantee the seal between the
housing and the worktop, stick the foam seal
around the edge of the frame
(Fig. 02
).
•
49 cm mini
3 cm mini
30 cm
mini
56 cm / 26
,5 cm
30 cm
mini
5,8 cm mini
70 cm mini
Fig. 01
Fig. 02
Housing
Seal
APPLIANCE
(60 cm model)
Standard
cabinet
cut-out
Total
dimensions
above
the work
surface
Total
dimensions
below
the work
surface
Width
56 cm
71 cm
55.4 cm
Depth
49 cm
52.2 cm
47 cm
Thickness
depending
on
cabinet
5 cm
5.1 cm
APPLIANCE
(30 cm model)
Standard
cabinet
cut-out
Total
dimensions
above
the work
surface
Total
dimensions
below
the work
surface
Width
26.5 cm
29,3 cm
26,3 cm
Depth
49 cm
52,5cm
47,9 cm
Thickness
depending
on
cabinet
5,4 cm
5.1 cm
7
EN
