Fagor CNC 8060, Hardware Configuration

Page: 58 / 112

Hardware configuration.
CNC 8060
4.
·58·
(R
EF
: 1709)
CN6
0-10H /
C
N
60-10
HT CN6
0-10V /
CN
60-10
VT
CN60
-1
0
K.
4.7.4 Probe connection.
Connector pinout.
Plug-in part 8-pole Phoenix-contact minicombicon connector (3.5 mm pitch).
The CNC offers two 5 V probe inputs and two 24 V probe inputs. The following diagram uses
the first probe input (pins 1/3 for 5 V or pins 5/7 for 24 V); For the second input, use pins 1/4
for 5 V or pins 6/7 for 24 V. Pins 2 and 8 are common.
All the shields of the cables must be connected to ground only a the CNC through pin ·8·
of the connector, leaving the other one free. The wires of the shielded cable must not be
longer than 75 mm without the protection shield.
Probe connection.
Probe whose output has a normally open contact. Connection to +5 V.
The connection acts upon the up flank (positive pulse) of the probe signal.
Probe whose output has a normally open contact. Connection to +24 V.
The connection acts upon the up flank (positive pulse) of the probe signal.
Connect GND of 5V power supply to pin 1.
Connect GND of 24 V power supply to pin 7.
Pin. Signal. Description.
1 GND_5V 0 V reference signal for 5V.
2 +5 V 5 V output.
3 PRB1_IN5V 5 V input of probe 1.
4 PRB2_IN5V 5 V input of probe 2.
5 PRB1_IN24V 24 V input of probe 1.
6 PRB2_IN24V 24 V input of probe 2.
7 GND_24V 0 V reference signal for 24 V.
8 Chassis Shield.
PROBE
8
2
1
3
5
Chassis
+ 5 V
GND_5V
PRB1_IN5V
PRB1_IN24V
PROBE
8
2
7
3
5
Chassis
+ 5 V
GND_24V
PRB1_IN5V
PRB1_IN24V
+ 24 V