17
1. The display may occasionally show the
error message "Err". If this happens,
either switch off the scales for a
moment or remove the battery for
complete reprogramming. Then switch
on the scales again for them to resume
functioning.
2. When you switch on the scales, all the
segments will light up at once. This
shows they are all functioning correctly.
3. "-----": the voltage indicator sensor zero
point has been programmed too far
below the lowest rating. The scales
cannot function correctly.
4. "Err": there is an overload or the voltage
indicator sensor zero point has been
programmed to far above the highest
rating.
5. "Err-H": the body fat level index
calculated is too far above the upper
limit.
6. "Err-l": the body fat level index
calculated is too far below the lower
limit.
7. If the screen stops working or cannot be
switched off for a long period of time,
remove the battery for around 3
seconds then insert it again to eliminate
the temporary failure.
11. ERROR AND OTHER MESSAGES
ON THE DISPLAY
1. The body fat and body water content
measured using body fat monitoring
scales is for guidance purposes only.
Your physical appearance will not
necessarily coincide with the readings
for body fat and water, and people of
the same age, sex and physical build
will not always give the same reading.
Consult your doctor to determine the
best hydration and body fat conditions
you should be aiming for.
2. Body fat control scales are not suitable
for use by people with the following
characteristics:
13. READ THE FOLLOWING NOTES
CAREFULLY FOR A CORRECT
UNDERSTANDING OF THE
APPLICATION AND THEORY OF THE
APPLIANCE
•
The scales may be slippery when wet.
Make sure they are dry before using them.
12. MAINTENANCE, CLEANING AND
CORRECT USE
•
Clean the scales with a dry cloth and
prevent any water from entering them.
Do not use strong cleaning chemicals
such as alcohol or benzene.
•
Keep the scales in a cool dry place,
rather than in a damp or hot place.
•
Keep the scales in horizontal position
rather than vertical, as the batteries
may run down.
•
Do not attempt to open the scales to
repair them, as this will nullify the
guarantee.
•
Do not drop the scales on the floor or
jump onto them when you use them.
Avoid any knocks and do not shake the
scales, as they are a precision
appliance. Their structure is delicate
and sensitive to any external impact.
•
If the scales do not work when you
switch them on, make sure a battery
has been inserted and that it has not
run down. Replace the battery and
consult your supplier if necessary.
interior 5/7/05 19:48 Página 16
