1
3
2
4
5
A
10
13c
13c
English
26 EN
Block function
When the machine is blocked, a warning message appears
on the display: if the key corresponding to the requested
wash cycle is pressed (key
26
) or key (
28
)) and the
instructions on the display are followed, the wash cycle is
performed and the machine is no longer blocked.
For example, if there is a "coffee block", the following
message appears on the display:
The number of the "blocked group" blinks on the display
and depends upon the number of machine groups.
If the coffee wash circuit key (
26
) is pressed, the previous
message will be integrated as shown:
When the "INSERT FILTER HOLDER - GROUP 1" message
appears, the block message for Group 1 disappears. The
block messages for groups still to be washed appear in
alternation.
At this point, follow the steps on the previous pages for
the wash cycle.
GROUP 1 LOCKED
EXECUTE WASHING
GROUP 1 LOCKED
EXECUTE WASHING
INSERT FILTER HOLDER
GROUP 1
Put a liter of cold water in a
suitable container and add
detergent.
Remove the
¿
lters from the
¿
lter-holders.
Soak the filters and the
¿
lter-holders in this solution
for about 15 minutes.
Place the
¿
lters back in the
¿
lter holder, making sure that
the anchoring spring (
A
) of the
¿
lter is in its slot.
FILTER-HOLDERS -
7KLVRSHUDWLRQPXVWEHPDGHRQDOOWKH¿OWHUKROGHUVDWWKHHQGRIHDFKZRUNLQJGD\
Remove any residue with a sponge and rinse well with
cold water.
Keep a hot water distributor key (
13a - 13c
) pressed down
for approximately 5 seconds.
The following message will be displayed: “
WATER
CHANGE
”. The water from the boiler will drain from the
hot water nozzle (
10
) (60 - 70% ca. of the total capacity).
Dispensing will stop automatically.
After the procedure, the machine will return to its normal
functions and the boiler will be re
¿
lled with fresch water.
CHANGING THE WATER IN THE BOILER - Procedure to carry out at least once a day
02_EmblemaR_1442.indd 26
21/10/2014 09:41:50
