-
+
-
+
-
+
English
18 EN
Counters are displayed by pressing the
(
27
) key.
The following message appears on the display (
14
):
Parameters calculated are:
-
N. coffee
(number of coffee beverages)
-
N. water
(number of times water is dispensed)
-
N. steam
(number of times steam is dispensed using
the steam button)
-
N. steam
TS
(number of times steam is dispensed using
the turbosteam function)
-
N. steam + air TS
(number of times steam and air are
dispensed using the turbosteam function)
-
N. tot coffee
(total number of coffee beverages).
Counters can be zeroed by aligning the cursor on the
selected entry, pressing the “PRG” key (
29
), and then
pressing the “
+
” (
30
) or “
-
” (
31
) key.
Press the “RES” key (
24
) to con
¿
rm zeroing.
The "N. coffee" entry appears for as many times as there
are machine groups.
Note: Parameters that cannot be zeroed are:
- N. tot coffee
Press the “RES” key (
24
) to return to the main menu.
À
COUNTERS MENU
N° coffee gr. 1
01234
19. DATA menu - Counter display and zeroing
NOTE.
ONLY
if the item “
Customer Progr.
” is
set on “
YES
" and the item “
Program. block
” is
set on “
NO
".
To access programming press the “PRG” (
29
) key; the
following message will appear on the display:
Press one of the dispensing keys on the selection panel;
the relative led will remain on.
20. How to access the programming mode
Use the “
+
” (
30
) or “
-
” (
31
) keys to position the cursor
on the desired line, then press the “PRG” (
29
) key.
Always use the “
+
” (
30
) and “
-
” (
31
) keys to change
the setting; at this point there are two possibilities:
1) con
¿
rm the changes made by pressing the
OK
key
2) exit the menu and leave the settings unchanged by
pressing the “RES” (
24
)
key.
Note
: When modifying data, the cursor changes to "
Æ
", or a
slide bar with maximum and minimum settings will appear:
If the "
Customer Progr.
" is set to "NO", the following
message will appear on the display:
CUSTOMER PROG.
NOT ENABLED!
À
CUSTOMER PROG.
KEY MENU
02_EmblemaR_1442.indd 18
21/10/2014 09:41:34
