English
English
9.
Cleaning
Cleaning the cappuccino maker
This operation must be made at the end of each working day.
Fill a container with 1/2 litre of cold water and one dose of liquid
detergent (see product instructions).
Remove the suction (
65
) tube from the milk container and immer-
se it in the solution.
Press button (
42
) and repeat the operation until all the detergent
has been used up.
Disassemble the cappuccino maker (
29
):
Unscrew the knob and remove the cappuccino maker (
29
).
Remove the cover.
Unscrew the ring nut of the knob (
64
) and remove it.
Unscrew and remove the adjustment screw (
63
).
Prepare another dose of detergent and clean each piece.
Remove any residue with a sponge.
Reassemble the cappuccino maker.
Rinse, pumping out at least one litre of cold water.
1.
2.
3.
4.
5.
64
6329
65
Cleaning the groups
This operation must be made on all the groups at the end of
each working day
1)
Using a brush, clean the cover gasket.
2)
Insert the rubber disk into the filter-holder with its filter.
3)
Pour in a packet or dosing cupful of detergent powder
4)
Insert the filter carrier into the group and press the selection
button. After a few seconds, press the STOP button. Repeat
this operation a few times.
5)
Remove the filter-holder and clean the shower with a sponge.
6)
Flush each dispenser unit with water for about 30 seconds.
First right-hand dispenser unit with cappuccino-selection panel:
1) Remove the milk-aspiration tube from the milk container and rest it
against the grille of the cup-shelf basin.
2) Press one of the selection buttons. Wait a few seconds and press
the STOP button. Repeat this operation a few times. Be careful,
steam will come out of the cappuccino-makers dispensing spout.
Filter-holders
1) Put a liter of cold water in a suitable container and add detergent.
2) Soak the filter-holders in this solution for about 2 hours.
3) Remove the filters from the filter-holders and wash the parts in the
same detergent solution, using a small sponge.
4) Flush thoroughly with cold water.
5) Reinstall the filters in the filter-holders, making sure that filter-
retainer spring seats properly.
2
1
