- 29 -
GB
Strabuc 918 and Strabuc 930
REMOVING ONLY THE POST OF STRABUC 930 HEAVY ARMOURED
It is possible to remove Strabuc 930 Heavy Armoured from its seat by following steps 1) and 2) as described in pic. 23.
But in order to remove only the retractable post, carry on with the steps as subsequently described in pic. 23.
1)
2)
3)
Strabuc 930
Heavy Armoured
Strabuc 930
Heavy Armoured
Strabuc 930
Heavy Armoured
Strabuc 930
Heavy Armoured
Strabuc 930
Heavy Armoured
PIC. 23
4)
5)
6)
7)
M10
M10
To remove only the retractable post: with the Strabuc 930 Heavy Armoured version
raised using the winch, unscrew the
three clamping nuts
and respective washers,
positioned below the Cylindrical container.
ATTENTION: during this operation the cylindrical housing will drop: it is
therefore recommended to support it.
Unscrew the
Cap
protecting the
Armoured lock barrel
using the
triangular profile key
Remove the three
Eyebolts
, the post
Cover
, the
Rubber edge
and the
Drilled flange
Unscrew the three
long hexagonal nuts
with their respective
Clamping screws
and
remove the
Retractable post
to leave the
Piston - hydraulic main unit
set exposed
Remove the whole
Reinforced Lock Barrel
by inserting the
personalised key and turn anticlockwise
Clamping nuts
and washers
IMPORTANT: do NOT loosen or tighten the three
axial alignment dowels of the internal group.
- VIEW FROM BELOW -
CYLINDRICAL HOUSING
Protection cap
Eyebolts
Post cover
Rubber edge
Drilled flange for
edge tightening
Manual release
cover security
flap
Armoured lock barrel
Personalised key for
armoured lock barrel
Triangular
profile key
ATTENTION: during the assembly phase it is important to
reposition the internal unit in exactly the same position as
before without screwing or loosening the three axial
alignment dowels.
