INSTALL THE ELECTRONICS
Photos in this section are of Paul’s truck fresh from the 2012 Motorama race.
EL1) Check the Tuning Section and set-up sheet to determine where you will
install the servo. We offer two different locations, forward and back. Here
we have used the forward mounting holes. Use the flat head screws you
saved and the servo mounts, which should still be attached to your servo.
Arrows in the left photo point to the front two holes, which is where the
screws are. In the right photo, the short arrow points to the rear hole,
which is not used here. Connect the servo link to the steering bellcrank as
before on your SC10 (long arrow). Paul mounts his transponder on top of
the servo with double-sided tape.
EL2) Mount the speed control on the
right side of the chassis with
double-sided tape behind the front
top deck support. Paul puts the
wires to the right so he has the
shortest distance to the motor and
puts the switch flat on the chassis
with double-stick tape just ahead
of the E.S.C.
EL3) Mount the receiver on the left side of the
chassis with double-sided tape behind
the front top deck support. The antenna
wire faces forward so the tube is close
by. To prevent glitching, be certain the
antenna wire touches only the tube.
