E8)
Repeat steps E4 – E7 to install
the left hub carrier on the right
arm.
INSTALL THE ARMS
We are using a new build sequence for this operation.
E9)
Place the hinge pin bushings (XF6142) in their slots in the hinge pin brace.
E10) Place the hinge pins into the
bushings.
E11) Check the set-up sheet and tuning section to determine whether your
control arm inner pivot will be forward, center, or rear. Here we are using
arms rear, so the shims go on the front. We use some extra 0.090”
transmission shims; shock limiters, flat washers, almost any shim of the
correct size will do. If your set-up is arms back, slide the shims on the
hinge pins now.
