2. REMOVE THE SIDE BROOMS FROM THE
SHIPPING BOX.
3. INSTALL THE SIDE BROOMS ONTO THE MOTOR
SHAFT, BY SLIDING THEM UPWARDS. LINE UP
THE HOLES AND INSTALL THE CLEVIS PIN WITH
SAETY CLIP
(SEE FIGURE 10.)
4. YOU MAY NEED TO ADJUST THE SIDE BROOM
HEIGHT, BY USING THE ADJUSTMENT SCREW.
MACHINE PREP
UNCREATING MACHINE
CAREFULLY CHECK THE CRATE FOR ANY SIGNS OF
DAMAGE. BATTERIES ARE IN THE UNIT.
TO UNCREATE THE MACHINE, REMOVE BANDING FROM
AROUND THE CRATE. TAKE OFF THE TOP AND SIDES
AND DISPOSE OF PROPERLY. REMOVE BANDING
FROM MACHINE. REMOVE THE CHOCKS AROUND
THE DRIVE WHEELS. FOLD DOWN RAMP, AND ROLL
MACHINE OFF OF THE BASE. NOTIFY THE CARRIER
IMMEDIATELY IF CONCEALED DAMAGE IS DISCOVERED.
CONNECTING BATTERIES
YOUR MACHINE IS EQUIPPED WITH (TWO) OR (FOUR) 12
VOLT, DEEP CYCLE, 185 AMP HOURS BATTERIES, WHICH
FORM A 24 VOLT SYSTEM.
1. TURN ALL SWITCHES TO THE OFF POSITION AND
REMOVE KEY.
2. OPEN REAR HOOD TO ACCESS THE BATTERY
COMPARTMENT.
3. BOTH OF THE TWO BATTERY CABLES ARE
CONNECTED TO THE BATTERIES. LOCATE THE GREY
50 CONNECTOR AND CONNECT THE TWO.
(SEE FIGURE 8.)
4. TURN ON MAIN POWER SWITCH AND CHECK
THE BATTERY CONDITION METER TO ENSURE
CORRECT INSTALLATION. CHARGE BATTERIES IF
NEEDED. (SEE: BATTERY CHARGING)
1. LOWER THE SIDE BROOM LINKAGE BY PULLING
BACK ON THE LEVER AND THEN SLIDING THE
LEVER ALL THE WAY TO THE REAR.
(SEE FIGURE 9.)
PAGE 9
ATTACHING SIDE BROOMS
(FIGURE 8.)
(FIGURE 9.)
(FIGURE 10.)
