MACHINE SETUP
REPLACING MAIN BROOM
PAGE 10
1. TURN THE MACHINE OFF. USE A 9/16 INCH
WRENCH TO REMOVE THE 3/8-16 HCS SCREW
AND REMOVE THE IDLER ARM.
(SEE FIGURE 11.)
2. THE MAIN BROOM SHOULD SLIDE OUT THE SIDE
OF THE MACHINE EASILY.
(SEE FIGURE 12.)
3. SLIDE THE NEW BROOM IN. WHEN YOU GET THE
BRUSH ON THE DRIVER SPIN IT WITH YOUR HAND
UNTIL YOU FEEL IT CATCH ON THE DRIVER AND THEN
PRESS IN COMPLETELY ON.
(SEE FIGURE 13.)
4. WHEN THE MAIN BROOM COMPLETLY INSTALLED
REPLACE THE IDLER ARM AND THE FASTENERS.
THE ARM SHOULD GO ON EASILY, AND METAL
TO METAL. IF THERE IS ANY GAPS LEFT BEFORE
TIGHTENING, IT HAS NOT BEEN INSTALLED
PROPERLY.
(SEE FIGURE 14.)
NOTE: SELECT THE BROOM FIBER THAT BEST MEETS YOUR CLEANING APPLICATION
CONSULT YOUR LOCAL CEALER FOR ASSISTANCE.
(SEE BRUSH TYPES ON PAGE 4.)
WARNING:
IF THE BROOM IS NOT FULLY ENGAGED
WITH THE DRIVERS, THE BRUSHES WILL
BE DAMAGED. DO NOT FORCE THE
IDELER ARM BACK ON. THIS USUALLY
INDICATES IMPROPER INSTALLATION
(FIGURE 11.)
(FIGURE 13.)
(FIGURE 12.)
(FIGURE 14.)
