Crossover™ Manual V1/62920016 ©Fabtech Systems LLC. All Rights Reserved.
Sports Set-Up
There are two common sport mode applications for this knee:
1. Low Impact: SUP, hiking, golfing, snorkeling, snow shoeing, etc.
2. High Impact: downhill skiing, alpine skiing, snowboarding, moto, skydiving, etc.
Low Impact Sport
For low impact applications the Crossover™ can be utilized in the “Walk Mode” with the addition of more
air pressure to get desired resistance levels while adjusting the shock adjustments to fit the ideal 3 posi-
tion (Blue Lever) operating range.
High Impact Sport
For high impact applications the Crossover™ will need to be converted to the X/CAM™ sport mode con-
figuration.
This conversion can be done in just minutes while the patient is wearing the knee with a rotator device
(this is suggested)
in the knee or simply by removing the leg and making these changes.
Required Tools: 3, 4, 5mm Allen wrench & Phillips screwdriver
Step 1. X/CAMs™
Using a 3mm Allen tool, remove the screws on both side covers. Place in bag
for safe keeping.
Using a 4mm Allen tool, attach the X/CAMs™ to the sides of the Crosso-
ver™. Torque to 8nm.
Step 2.
Lower Tendon Guide Rollers
Using a 5mm Allen wrench remove the rubber caps on the lower part of
Crossover™, replace with rubber tendon rollers and re-install. NOTE: all
screws/ bolts are pre-Loctite but with frequent removal and re-install you may
want to re-Loctite with Blue 242. Hand tighten.
Installing X/CLIPs™ and Lower Tendon Mounts and X/CAM™
15
