Faber Triple Premium XXL, Manual

Page: 14 / 26

Installatie handleiding
14 < < < <
90° bends which are used to switch from vertical to
horizontal or vice versa (Fig. 12.2 and 12.3 G, O and
S)

Bends 45° or 30 ° vertical to horizontal
plane
These are 30° or 45° bends used within the vertical
plane (Fig.12.1 B and D).

Pipes running upwards at an angle:
These are pipes which are ascending at an angle of
30° or 45° from the horizontal. (Fig. 12.1 C). Fill in
only in combination with at least 2 x 30 or 45°
bends in the vertical part.

Table:
Select from the table the correct vertical (TVH) and
horizontal length (THL).
If the result is “x” or if the values are outside the
table, then the combination is not allowed. The
TVH or THL can be adjusted to achieve a viable
system.
If a value is indicated, check that the calculated STL
value is not lower than indicated in the table. In
this case STL must be adjusted.
The resulting value indicates the width of the flue
restrictor (“0” means no restrictor) required
30mm restrictor is installed as standard by the
factory and each fire is supplied with a full set of
restrictors. (fig.4.2)