Faber SERENE C11, Installation Manual

Page: 10 / 24

9 < < < <
UK IRL
4 Instruction for Installation
4.1 Gas Connection
•
Installation pipes should be in accordance with BS 6891. Pipe work from the meter to
the appliance must be of adequate size.
•
The complete installation including the meter must be tested for soundness and
purged as described in the above code.
•
A means of isolation must be provide in the supply to facilitate servicing. The
connection should be made in 8 mm copper or similar semi flexible tube. (max 1
meter). Ensure that the gas pipe does not interfere with the removal or replacement
of the burner tray or of the controls. The gas connection is nut and olive suitable for
8 mm pipe.
4.2 Electric connection
Always place a domestic power socket (230VAC – 50 Hz) near the appliance
4.3 Preparing the appliance
•
Remove the frame (see 4.9 and 4.10)
•
Take the box with the log set out of the combustion chamber.
•
Place the right flue restrictor in the combustion chamber. To determine the right flue
restrictor, see appendix A & B
4.4 Placing the appliance in an existing chimney breast
If possible, first locate the appliance before assembling the flue. If this is not possible then
always use an extendible pipe before connection onto the appliance.
•
Check if the floor and wall are sufficiently level. If not, you should fix this
•
Prepare the gas connection
•
Position the firebox in the fireplace opening.
•
Make the gas connection according to the instructions (also see gas connection, chapter
5.1)
•
Assemble the flue system onto the firebox (see chapter 5)
•
Check if applicable that the safety hatch seals the combustion chamber properly. Do not
fasten it at all! If you fasten it, this explosion safety hatch won’t function properly!
•
Place the log set (see placing log set, chapter 5.4).
•
Place the glass; check the glass sealing rope is in good condition and makes an effective
seal. Be sure that there are no fingerprints on the glass. It is not possible to remove