Version 09/05 - Page 6
PREPARE THE WALL
1.
Disconnect and move freestanding range from cabinet open-
ing to provide easier access to rear wall. Put a thick, protective
covering over cooktop, set-in range or countertop to protect from
damage or dirt.
2.
Determine and clearly mark with a pencil the center line on the
wall where the rangehood will be installed.
3.
Draw a horizontal line at 43" above the cooktop
(as indicated
in FIGURE 4).
Mark two points (1)
(in FIGURE 4)
on the horizontal
line, 7 7/8" away from the center line on each side. Make sure both
marks are level.
4. Mark two points (2)
(in FIGURE 4)
which are 19 7/16" above
the cooktop, and are 7 1/16" on either side of the center line. Make
sure both marks are level.
FIGURE 5
5.
In holes (1)
(in FIGURE 4)
attach the two mounting brackets
(B) to the wall with 2 mounting screws.
6. In holes (2)
(in FIGURE 4)
put one safety screw (G) in each
hole, do not tighten the screws all the way.
B
F
G
FIGURE 4
INSTALL THE RANGEHOOD
1.
Open the ducting panels on the rangehood. Disconnect
the 4 panels from the hood by sliding the fixing pin lever
(as
indicated in (A) FIGURE 5).
2. Using two hands, remove the grease filters one at a time
by pushing the filter forward and and pulling the handle
down.
(FIGURE 6)
3. Adjust the two adjusting screws on the mounting hardware
(B in FIGURE 5)
to the lowest point
FIGURE 6
FOR ALL INSTALLATIONS
1.
Remove the cover from the Field Wiring Compartment with
a phillips screwdriver. Feed the Power Supply Cable through
the electrical knockout. Connect the Power Supply Cable to the
rangehood cable. Attach the Power Supply Cable grounding
lead to the green screw provided. Attach the White lead of the
power supply to the White lead of the rangehood with a twist-on
type wire connector. Attach the Black lead of the power supply
to the Black lead of the rangehood with a twist-on type wire
connector. Using the 4 holes provided screw the Field Wiring
Compartment to the wall as dictated by your Power Supply
Cable location (screws not provided). Replace the cover.
WARNING: THE SCREWS PROVIDED FOR MOUNTING THIS
RANGEHOOD MUST BE INSERTED INTO SOLID WOOD. THESE
MUST NOT BE INSERTED INTO SHEET ROCK.
4. Hang the rangehood on the two mounting screws and
from the inside of the hood, adjust the mounting screws to
make the hood level
(B in FIGURE 5)
.
5. Tighten the safety screws
(Hole 2, in FIGURE 4)
6.
For ducted installations, the DAMPER
(J in FIGURE 1)
must be attached to the exhaust opening at the top of the
CANOPY SECTION. Connect the ductwork and seal all
connections with duct tape.
15"
19 7/16
"
43
"
