>
>
>
>
23
7) Connect the wires to the gas valve. (see fig. 19).
8) Check that there are batteries in the transmitter.
9) Set the on/off switch on the receiver to "on".
Setting the right transmission code
The receiver has to learn the code from the transmitter, which is already
set at the factory. However the code disappears if the receiver is
disconnected for a longer period, or when you use the transmitter out of
the range of the receiver for more then 15 times. Then the code doesn't
match the code in the receiver
1)
Push the "mod" button on the receiver, hold it for 3 seconds.
2)
The green control lamp will light up and stay on. Repeat not.
3)
Push a button on the remote control. The control lamp on the
receiver should now go out.
4)
Again push a button on the remote control. The lamp starts flashing
and will switch off eventually.
5)
The receiver now recognizes the remote control. The remote control
now functions.
6)
Check if you can hear a sound and the motor runs when you push a
button on the remote control
Fig. 20
Summary of Contents for FEELING
Page 2: ...2 ...
Page 12: ...12 ...
Page 36: ...36 USER GUIDE ...
