20
Carefully unpack the fire and save the packaging for any future use (in case of moving house or returning the fire to
the supplier).
The fire has a flame effect that can be used with or without the heating.
Before connecting the fire, check whether the supply voltage is the same as the voltage indicated on the fire.
Note: If you use the fire in an area with little background noise, you may hear a sound when the fire is turned on with
the flame effect. This is normal so do not worry.
KEEP THIS MANUAL FOR FUTURE REFERENCE
Use only water with a hardness of maximum 10dH. Ask your water company what is the hardness of your tap
water. Decalcify the water or use demineralised water in case of a higher level of hardness.
If you don't use the fire for 2 weeks or longer, we advise you to remove the water from the receptacle and the
filling tank and to dry the receptacle.
Once the fire is in use, it may not be moved or set on its back without removing the water from the receptacle
and the water tank.
The water tank, receptacle, receptacle cover, tank cover and air filters should be cleaned once a fortnight - in
the case of intensive use of more than 2 hours per day they should be cleaned weekly.
Never use the apparatus if the lamps do not work.
The lamps should be checked regularly as described in 'Maintenance' and 'Replacing the lamps'.
GENERAL INFORMATION
The manual control of the Opti-myst is located at the bottom of the apparatus. (See Figure 2 for a diagram of the
manual control.)
Switch 'A': This is the main switch of the fire.
Remark: This switch must be in the 'ON' (
I
) position, because the fire will not work otherwise.
Switch 'B': Push
once to turn on the flame effect. The heating will remain off. This is indicated by a single beep.
Although the main lamps will work immediately, it takes another 30 seconds before the flame effect starts to function.
Push
again to combine the flame effect with the heating on 50% of the capacity. This is indicated by two
beeps.
Push
again to combine the flame effect with the heating on maximum capacity. This is indicated by three
beeps.
Push
again to return to only the flame effect. This is indicated by a single beep.
Push
to set the fire on standby. This is indicated by a single beep.
Control knob 'C': regulates the setting of the thermostat.
Turning the knob towards you lowers the temperature setting. Turning the knob away from you increases the
temperature setting.
Installation
Make sure that all packaging is removed. (Read the warning labels carefully.)
Save the packaging for any future use.
Make sure that the apparatus is spirit-level mounted on the wall.
Installation of the fire (see Figure 1)
1. Remove the wall bracket at the backside of the apparatus by removing the two screws with which the wall bracket is
attached.
2. Mount the wall bracket on the wall using the supplied plugs and screws for concrete walls. Make sure that it is spirit
level.
3. Hang the apparatus from the mounted wall bracket. Turn the safety mounting bracket at the bottom of the product
in such a way that the mounting hole is visible. Mark the location of this hole and remove the apparatus from the wall.
Drill a hole and place a plug in the wall in the indicated position.
4. Hang the apparatus back on the wall bracket attached to the wall. Secure the apparatus by means of a screw
through the safety mounting bracket.
Make sure that the fire is
OFF:
Insert the plug of the fire into a wall socket.
You have to fill the water reservoir before you use the control knobs (see ‘Maintenance’, ‘ Filling the water
reservoir’).
I
nstallation
I
nstruction
Operating the Fire
