5.
The canopy attaches to the two mounting screws by two hooks inside the rangehood
(FIGURE 10)
. Before mounting
the canopy, the hooks must be extended outside the canopy to attach to the mounting screws in the wall. Hook the canopy to
the eye bolts
(O in FIGURE 10)
. Adjust the support rod
(B in FIGURE 11)
so that it pushes against the wall. The hooks are
adjustable in/out to secure the canopy to the wall
(L in FIGURE 12)
and up/down
(N in FIGURE 12)
to level the canopy. Insert
the gray plugs
(T in FIGURE 12)
provided into the holes which give access to screws
(N in FIGURE 12)
.
FIGURE 10
FIGURE 11
FIGURE 12
Version 02/02 - Page 6
FIGURE 13
I
NSTALL THE CHIMNEY
1.
Loosen the screws
(M in FIGURE 13)
fixing the two parts of the chimney and pull the inner section
(I in FIGURE 13)
all
the way out. Remove the protective film
(P in FIGURE 13)
.
2.
Rest the lower section of the chimney in its housing on the top of the canopy. Lower the ducting unit until it reaches the
upper bracket
(S in FIGURE 14)
and attach it using the screw
(H in FIGURE 14)
provided. Fit the cover
(D in FIGURE 14)
on
the upper bracket. Make the duct connections, but not the electrical connections at this time.
FIGURE 14
3.
Attach the chimney to the canopy using the four screws provided
(E in FIGURE 15)
. Insert the transparent seal provided
(Q in
FIGURE 16)
so as to eliminate any play between the two parts of the chimney. Tighten the chimney screws
(M in FIGURE
13)
. Remove the support rod
(B in FIGURE 15)
.
4.
Connect the internal electrical cable. The connector for the canopy end of this cable is located under the left side gray panel
inside the canopy. This panel can be removed by removing a phillips screw in the hole next to the chimney opening
(FIGURE
17)
.
FIGURE 15
FIGURE 16
FIGURE 17
5.
Connect the Power Supply Cable to the rangehood The field wiring compartment is located on top of the blower. Attach the
White lead of the power supply to the White lead of the rangehood with a twist-on type wire connector. Attach the Black lead of
the power supply to the Black lead of the rangehood with a twist-on type wire connector. Connect the Green ( Green and Yellow
) ground wire under the Green grounding screw.
6.
For ductless installations, charcoal filters must be installed
(FIGURE 18)
.
7.
Replace the field wiring compartment cover and the grease
filters. Turn the power supply on. Turn on blower and light. If
the rangehood does not operate, check that the circuit breaker
is not tripped or the house fuse blown. If the unit still does not
operate, disconnect the power supply and check that the wiring
connections have been made properly.
FIGURE 18
