FAAC S800H ENC, Manual

Page: 6 / 20

6 532096 Rev. B S800H ENC
A B
C
A B
1
1
ENGLISH
T
ranslation of the original instructions
Insert the key without moving the pinion and check
that it is at the following position
Fig.6
Fig.7
Fig.8
Fig.9
7) Remove the adjustment key, screw the cap of the limit switch
screw and grease the operator pinion.
8) Using the specific handles, insert the operator in the support
box figure 7, and position it as shown in figure 8 A, B.
9) Close the gate (Fig.9).
Fig.10
Fig.11
10) Lift the operator using the specific panels
(Fig.10 ref.A ), and insert the pinion in the splined bush of the
support box. To facilitate the operation, turn the operator until
they couple.
11) Position the supplied key beneath the operator as shown in
figure 10 ref. B to support the engine.
12) Insert and screw the fixing screws with the groover as shown
in figure 10 ref. C, to secure the operator to the support box, as
in figure 11.
13) Open and close the gate, checking the respective limit
switches, as described in chapter 5, and adjust them if necessary.
14) Hydraulically lock the operator according to the instructions
in chapter 7.1.
15) Perform the electrical connections, as described in the in-
structions of the electronic equipment, paying attention to the
polarity of the encoder.