FAAC S800H ENC, Manual

Page: 16 / 20

8 532096 Rev. B S800H ENC
90°
A B
C
A B
ENGLISH
T
ranslation of the original instructions
Fig.16
Fig.17
Fig.18
Fig.19
Fig.20
Fig.21
Fig.22
5 INTERNAL MECHANICAL LIMIT SWITCHES
(POSITIVE STOP)
The S800H ENC operator is supplied, as per standard, with internal
opening and closing mechanical limit switches. This facilitates
installation as you do not need to make mechanical stops.
The mechanical limit switches (POSITIVE STOP) can be adjusted
in the last 30° of the operator's MAXIMUM stroke, opening
and
closing.
FAAC SUPPLIES THE LIMIT SWITCHES FULLY OPEN (MAXIMUM PINION
ROTATION ANGLE).
11) Ring the released gate to the open position, checking that the
release part freed from the gate
remains at the closed position
as in figure 20 ref. .
12) Lift the operator using the specific panels
(Fig.21 ref.A ), and insert the pinion in the splined bush of the
support box. To facilitate the operation, turn the operator until
they couple.
13) Place the supplied key beneath the operator (Fig.21 ref. B)
to support the engine.
14) Insert and screw the fixing screws with the groover (Fig.21
ref. C, to secure the operator to the support box, as in figure 22.
15) Close the gate and secure it to the mechanical release.
16) Open and close the gate, checking the respective limit
switches, as described in chapter 5, and adjust them if necessary.
17) Hydraulically lock the operator according to the instructions
in chapter 7.1.
18) Perform the electrical connections, as described in the in-
structions of the electronic equipment, paying attention to the
polarity of the encoder.