FAAC MiniTIME SA, Installation Manual And User Manual

Page: 7 / 7

MiniTIME SA: Installation Guide and User Guide
Pag. 7
C
OMANDO
D
ESCRIZIONE
D
EFAULT
E
SEMPIO
10# F E Wiegand/MagStripe Interface F = 1 → Wiegand, F = 0 → MagStripe MagStripe
5.7 Menu 8 – Internal/External reader activation
To enter the menu read paragraph Errore. L'origine riferimento non è stata trovata. – Errore. L'origine riferimento
non è stata trovata.
C
OMANDO
D
ESCRIZIONE
C
OMANDO
D
ESCRIZIONE
1#1E Enable RF module for passive cards (Default) 1#0E Disable RF module for passive cards
2#1E Enables Reader B 2#0E Disables Reader B (Default)
5.8 Special Commands
These commands can only be managed from outside the configuration menu. In the following tab MC indicates the
Master ‐ Code.
C
OMANDO
D
ESCRIZIONE
C
OMANDO
D
ESCRIZIONE
65000# MC All Absent 65001# MC All present
65300# MC Reset titles archive 65301# MC Reset settings
65534# MC Reset Master ‐ Code (a new one is needed) 65535# MC Reset to Default
The # key can be omitted when a “Master ‐ Card” is used.
6 Reset Functions
Reset Functions are particularly helpful when the “anti ‐ pass ‐ back” features are used. These Fuctions enable the user to set the
status of all the titles to a specific value.
The reset 1 function enables the MINITIME ‐ SA to consider all the titles as absent (all titles are out the controlled area). The
feature is activated upon using a card or by code imput on the keyboard of any of the readers.
The reset 2 function has a similiar function: this function can take place in two ways, it enables the MINITIME ‐ SA to consider all
the titles as absent or present, depending on which reader is used for the operation: if the code/card is used on an entrance
reader all titles will be considered present, if it is used on an exit reader all the titles will be considered absent.
7 Note dell’Installatore